Service

Service and aftermarket

Test of safety functions.
Clean internal tubes for soot (soot will reduce the performance considerably, 3mm of soot results in a heat loss of abt. 40%).
Oil supply line (filter etc).
Components check of the burner.
Spark Arrestor.
Check pressure settings.
Control of door gaskets and door isolation.
Check electrical heating elements.
Adjust the oil burner settings with exhaust gas analyser (if burner burning with to much air you can reduce loss up to 5 %).
Check burner plate and isolating ring.

Opportunities for upgrading to new burner for optimization of combustion.
Mounting of a fuel flow meter to control fuel consumption.
Retrofit turbulators in burner pipes for a higher efficiency (not possible for all models).
Retrofit with more electric elements in order to increase efficiency.
Upgrade of Control system with a 7″ touch, ready with modbus RTU communication.
Upgrades of older Saniterm and Kay Lindegaard Incinerators.
Installing Tosibox in systems with PLC to enable remote assistance.

Critical parts such as the burner and the control system is subject to being worn out over time, even though the steel stays in good condition.

Upgrading these components will ensure operational stability and class requirements being met for several years.

Ask us for a non-binding quote to upgrade your system.